NOTE: This article is a WIP. This notice will be removed when completed 4th Gen Fuel Tank Swap 99-02 (Plastic Tank)[…]
Read more
Latest POSTS
Below you will see brief excerpts with a link to the latest technical articles. Feel free to leave comments on the posts for any tips/tricks or even corrections
Clutch Pedal Rod End Dimensions
This is a comparison between the 4th gen tick adjustable master cylinder rod end, and the hawks 3rd gen rod[…]
Read more
Fuel Line Sizes
Factory line sizes are: 3/8″ FEED 5/16″ RETURN 3/8″ Steel Line to -6AN Adaptor Earl’s 165006 Aluminum -6AN Male to[…]
Read more
Trap Door – The Correct Way
FUEL ACCESS HOW-TO – Using 4th gen plastic tank The point of this article is to show everyone the proper[…]
Read more
Basic Starting / Charging Diagram
This is a general guide on how to wire up the starting and charging system for a LS1 going into[…]
Read more
PS Gearbox Fitting Sizes
Fittings into the gearbox: 18mm x 1.5 o-ring 16mm x 1.5 o-ring I believe the larger one is the pressure[…]
Read more
LS Starter Bolts – Various Dimensional Sizing
Starter bolts vary in LENGTH due to the different starters used on different LS configurations The thread pitch is the[…]
Read more